Jump to content
Sign in to follow this  

Missing pads on 12-pin controller board connector - Any workarounds?

Recommended Posts

Hey guys,


Take a look at the following pictures.  This board is an Atari 2600 six-switch model and after pulling the 12-pin connector since I suspected a bad connector I found pads missing from some of the pin locations on top and bottom.  Any idea if there is a workaround for this problem, or is the board shot at this point?









Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this