Jump to content

3D Printed a 32k Sidecar Case


Recommended Posts

10 minutes ago, RickR said:

I finally took the time to print out a case for my TI 32k sidecar.  It was a little bit tricky because I had to add in a little cutout for a power connector on my board.  In the end, it turned out pretty well.

A little sanding and buffing on that case and it'll look 'store bought'! 

<<< My YouTube Page >>>

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...