Missing pads on 12-pin controller board connector - Any workarounds?

[Trellot]

Hey guys,

 

Take a look at the following pictures.  This board is an Atari 2600 six-switch model and after pulling the 12-pin connector since I suspected a bad connector I found pads missing from some of the pin locations on top and bottom.  Any idea if there is a workaround for this problem, or is the board shot at this point?

 

Thanks,

 

Trellot

 

 

[Atari 5200 Guy]

Those traces missing are fine. They don't appear to be connected to anything and most likely used as just an anchor. I wouldn't worry about them.

[Trellot]

Thanks for your input, yeah I've also decided to continue with this repair job.  We'll see how it turns out!

 

Thanks again for you input,

 

Trellot